Switch Managed Wall-mount 8-Porte 10/100/1000T 802.3bt PoE + 2-Porte 100/1000X SFP con LCD Touch Screen (-20 a 70°C)

Riferimento:WGS52258U2SVS

Descrizione

WGS52258U2SVS  Switch Managed Wall-mount 8-Porte 10/100/1000T 802.3bt PoE + 2-Porte 100/1000X SFP con LCD Touch Screen (-20 a 70°C)

Specifiche Tecniche
Copper Ports 8 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports
SFP Slots 2 100/1000/2500BASE-X SFP interfaces
Compatible with 100BASE-FX, 1000BASE-SX/LX/BX and 2500BASE-X SFP transceivers
PoE Injector Port 8 ports with 802.3bt PoE++ injector function with Port-1 to Port-8
RAM 128MBytes
Flash Memory 64MBytes
Reset Button < 5 sec: System reboot
> 5 sec: Factory Default
Connector 4-pin terminal block for power input
- Pin 1/2 for Power 1 (Pin 1: V+ / Pin 2: V-)
- Pin 3/4 for Power 2 (Pin 3: V+ / Pin 4: V-)
2-pin terminal block for event alarm
Alarm One relay output for power failure. Alarm Relay current carry ability: 1A @ 24V DC
Enclosure IP30 aluminum case
Installation Wall-mount
Dimensions (W x D x H) 245 x 36 x 140 mm
Weight 1,299g
Power Requirements 48~54V DC (>52V DC for PoE++ and PoE+ output recommended)
Dual power input is required for maximum power loading
Power Consumption Max. 14.72 watts/50.23 7BTU@50V DC input (Power on without any connection)
Max. 375 watts/1280BTU@Single 54V DC input (Full loading with 360 watts PoE function)
Max. 752 watts/2566BTU@Dual 54V DC input (Full loading with 720 watts PoE function)
ESD Protection 6KV DC
LED Indicator System:
- PWR 1(Green)
- PWR 2 (Green)
- Ring (Green)
- Ring Owner (Green)
Per 10/100/1000T RJ45 PoE++ Ports:
- 802.3bt PoE-in-Use (Green)
- 802.3af/at PoE-in-Use (Amber)
- 1000 LNK/ACT (Green)
- 10/100 LNK/ACT (Amber)
Per SFP Interface:
- 100 LNK/ACT (Amber)
- 1000/2500 LNK/ACT (Green)
Switching Specifications
Switch Architecture Store-and-Forward
Switch Fabric 26Gbps/non-blocking
Throughput (packet per second) 19.345Mpps@ 64 bytes packet
Address Table 8K entries, automatic source address learning and aging
Shared Data Buffer 4Mbits
Flow Control IEEE 802.3x pause frame for full duplex
Back pressure for half duplex
Jumbo Frame 9Kbytes
Power Over Ethernet
PoE Standard IEEE 802.3bt PoE++ Type-4 PSE
Backward compatible with 802.3at PoE+ PSE
PoE Power Supply Type - 802.3bt
- UPOE/POH
- End-span
- Mid-span
- Force
PoE Power Output 802.3bt PoE++
- Per port 52V~56V DC (depending on the power supply), max. 90 watts
UPoE(PoH)
- Per port 52V~56V DC (depending on the power supply), max. 95 watts
IEEE 802.3at Standard
- Per port 52V~56V DC (depending on the power supply), max. 36 watts
Force
- Per port 52V~56V DC (depending on the power supply), max. 60 watts
Power Pin Assignment End-span: 1/2 (-), 3/6 (+)
Mid-span: 4/5 (+), 7/8 (-)
802.3bt/UPoE: 1/2 (-), 3/6 (+),4/5 (+), 7/8 (-)
PoE Power Budget 48V Power input
- 125W maximum (depending on power input)
52~54V Power input
- Single power input: 360W maximum (depending on power input)
- Dual power input: 720W maximum (depending on power input)
※Dual power input must be the same as DC voltage, like dual 54V
Max. number of Class 3 PDs 8
Max. number of Class 4 PDs 8
Max. number of Class 8 PDs 8
PoE Management Functions
Active PoE device alive detects Yes
PoE Power Recycle Yes, daily or predeinded schedule
PoE Schedule 4 schedule profiles
PoE Extend Mode Yes, max. 160 to 200 meters
PoE System Management System PoE Admin control
Total PoE power budget control
Auto power input and PoE budget control
PoE Legacy mode
Over-temperature threshold alarm
PoE usage threshold alarm
PoE Port Management Port Enable/Disable/Schedule
PoE mode control
- 802.3bt
- UPoE
- 802.3at End-span
- 802.3at Mid-span
- Force mode
Port Priority
Layer 3 Functions
IP Interfaces Max. 8 VLAN interfaces
Routing Table Max. 32 routing entries
Routing Protocols Ipv4 software static routing
Ipv6 software static routing
Layer 2 Function
Port Configuration Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Port link capability control
Port Status Display each port’s speed duplex mode, link status, flow control status,
auto negotiation status, trunk status
Port Mirroring TX/RX/both
Many-to-1 monitor
VLAN IEEE 802.1Q tag-based VLAN
IEEE 802.1ad Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
MVR (Multicast VLAN Registration)
GVRP
Up to 4K VLAN groups, out of 4094 VLAN IDs
Link Aggregation IEEE 802.3ad LACP/static trunk
Supports 2 trunk groups with 2 ports per trunk group
Spanning Tree Protocol IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IGMP Snooping Ipv4 IGMP (v1/v2 /v3) Snooping
Ipv4 IGMP Querier mode support
Up to 255 multicast Groups
MLD Snooping Ipv6 MLD (v1/v2) Snooping
Ipv6 MLD Querier mode support
Up to 255 multicast Groups
Bandwidth Control Per port bandwidth control
Ingress: 500Kb~1000Mbps
Egress: 500Kb~1000Mbps
RING Supports ERPS, and complies with ITU-T G.8032
Recovery time < 10ms
Synchronization IEEE 1588v2 PTP(Precision Time Protocol)
- Peer-to-peer transparent clock
- End-to-end transparent clock
QoS Traffic classification based, strict priority and WRR
8-level priority for switching
- Port number
- 802.1p priority
- 802.1Q VLAN tag
- DSCP/TOS field in IP packet
Security Functions
Access Control List IP-based ACL/MAC-based ACL
ACL based on:
- MAC Address
- IP Address
- Ethertype
- Protocol Type
- VLAN ID
- DSCP
- 802.1p Priority
Up to 256 entries
Dettagli del prodotto
WGS52258U2SVS
16 altri prodotti della stessa categoria:

Menu

Settings

Click for more products.
Nessun prodotto trovato.